Applying Vinyl Decals

Your decal consists of 3 layers when you remove it from the envelope.

1. White backing
2. The decal
3. Clear "transfer tape"

To apply your decal:

1. Carefully/slowly peel the clear layer away from the white layer. The decal itself should remain stuck to the clear layer. If the decal sticks to the white layer, put the clear layer back down and use a flat object like a credit card to rub over the entire decal with a good amount of pressure. This will help the decal stick to the clear layer.

2. Carefully apply the decal where you want it. An easy way for small decals is to hold them at each end(tightly) and place them down flat. You could also place one end on the surface, and hold the other end tight while you run the edge of your hand along the decal, pressing it down as you go. Using one of these 2 methods will help you eliminate most air bubbles.

3. Rub the decal down with a good amount of pressure.

4. Carefully peel off the clear layer. Just the decal will remain on the surface!

That's It! Easy eh?